Nortel CALLPILOT Installation And Configuration Manual page 14

Part 2: 703t server hardware installation
Hide thumbs Also See for CALLPILOT:
Table of Contents

Advertisement

703t server description
The table below describes the parts that are identified in the preceding
diagram:
Part
Reset button
Network
controller LEDs
(green)
Sleep mode button
Power button
Status LEDs
USB connector
Floppy disk eject
button
Floppy drive
14
Function
Triggers a hardware (cold) reset. Do not use
this button to perform a server restart. Restart
the server as described in "Restarting the
server" in CallPilot Installation and
Configuration Part 1: Installation and
Maintenance Overview (555-7101-210).
Left: 10/100Base-T controller LED
(NIC1 10/100 MB: ELAN
for Meridian 1/Succession 1000 connection)
Right: 10/100/1000Base-T controller LED
(NIC2 1 GB: CLAN
for Customer LAN connection)
Not used
Turns the server's power on or off.
Indicate when the server is powered up and the
disk drives are active.
Left: hard drive activity LED (not used)
Center: power/sleep LED (green)
Right: status LED (bi-color) indicates
whether the server is functioning properly,
or whether a hardware event has occurred.
For future use
Ejects the floppy disk.
Drive for 3-1/2 inch diskettes.
Standard 1.01
CallPilot

Advertisement

Table of Contents
loading

This manual is also suitable for:

Callpilot 703t

Table of Contents