Nortel CALLPILOT Installation And Configuration Manual page 33

November 2005
Step Description
4 Replace the server cover.
5 Place the 703t server in the chosen location (see page 48).
6 Set the DIP switches on the modem (see page 51).
7 Connect the 703t server and devices as follows:
Connect the monitor, keyboard, and mouse (see page 53).
Connect the modem (see page 55).
Connect the 703t server to the ELAN hub (see page 57).
ATTENTION
If a hub is required or used, it must be located at least 6 m
(20 ft) away from the 703t server. This ensures compliance
with EMC requirements.
Connect the 703t server to the CLAN hub (optional); (see
page 59).
ATTENTION
If a hub is required or used, it must be located at least 6 m
(20 ft) away from the 703t server. This ensures compliance
with EMC requirements.
Install the software feature key adapter (see page 60).
Connect the power cords for all devices, and then power
them up (see page 62).
8 Start the 703t server (see page 64).
Part 2: 703t Server Hardware Installation
Preinstallation requirements
Check
❒
❒
❒
❒
❒
❒
❒
❒
❒
❒
33