Supported Peripheral Devices - Nortel CALLPILOT Installation And Configuration Manual

1001rp server description

Supported peripheral devices

Introduction
This section identifies external devices that are supported by the 1001rp
server. The following table describes the supported peripheral devices:
Device
Modem
Ethernet hub
Monitor, keyboard,
and mouse
24
Description
A 56 Kbps external modem (NTRH9078) provides
remote access to the 1001rp server. The modem connects
to the RS-232 COM1 connector on the rear of the server.
Since the modem is an external device, it requires its own
AC power source.The 33.6 Kbps modem (NTRH9016) is
also supported, but has been replaced by the 56 Kbps
modem for new systems.
A 10BaseT Ethernet hub provides the ELAN connection
between the 1001rp server and the Meridian 1 switch or
Succession CSE 1000 system. The customer can supply
a hub from third-party vendors or purchase the 3Com
10BaseT Ethernet hub (NTRH9017) from Nortel
Networks.
Since the hub is an external device, it requires an AC
power source.
„
14" monitor: NTRH9011
Since the monitor is an external device, it requires its
own AC power source.
„
Keyboard: NTRH9013
„
Mouse: NTRH9014
Standard 1.0
CallPilot