Inspecting The Server Interior - Nortel CALLPILOT Installation And Configuration Manual

Preinstallation requirements

Inspecting the server interior

Introduction
Before you install the server, you should perform a visual inspection for
loose components, foreign matter, or shipping damage inside the server.
.
To inspect the server interior
1 Ensure that all the cards are fully seated on the baseboard.
2 Check for any loose wires or foreign objects, such as loose screws,
inside the chassis.
3 Review the slot locations (see "Rear panel diagram" on page 16).
4 Do one of the following:
IF
you observe
any damage
components have
become loose
40
CAUTION
Risk of equipment damage
When working with interior components, use an ESD wrist
strap to protect static-sensitive components.
THEN
contact your Nortel Networks technical
support representative.
secure them. Then replace the server
cover and proceed with the hardware
installation.
Refer to the procedures in CallPilot
Installation and Configuration Part 5:
703t Server Maintenance and
Diagnostics (555-7101-227).
Standard 1.01
CallPilot