Hardware Reboot - HP StoreOnce B6000 Series Reference Manual

hardware reboot

Description of Command Function
Reboots the StoreOnce appliance nodes. If a file server node is defined in the command entry,
only this node is rebooted.
Command Syntax
hardware reboot [NODEX]
Command Authority
Administrator
Command Object Requirements
NODE X – As an option, this can be used to define an individual file server node. X is a unique
numeric index. NODEX is a label uniquely defining the hardware component. It was assigned
during the initial automatic hardware initialization and configuration. A complete list of the NODEX
labels can be obtained using the hardware show node status command (see
show node status" (page
nodes are defined, all the nodes in the appliance are rebooted.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to the command syntax.
At least one system with an active CLI must exist.
If a file serving node is defined in the command entry, the defined node must be powered on.
Successful Command Output
Upon successfully sending the reboot request, the following is displayed:
reboot request successfully sent
NOTE: This message only indicates the success for the reboot request. The hardware show
node status command (see
that the server nodes rebooted correctly. Also, if the reboot applies to the node currently supporting
the CLI interface, the session will terminate following this command.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
If the defined node is not powered up, the following is displayed:
Command Failed
defined for reboot in the command entry.
Example
# hardware reboot
reboot request successfully sent
29)). If a file server node is defined, only this node is rebooted. If no
"hardware show node status" (page
NODEX is not rebooted, where NODEX is the file server node
"hardware
29)) must be entered to verify
hardware reboot 27