Net Show Config - HP StoreOnce B6000 Series Reference Manual

net show config

Description of Command Function
Shows the network configuration.
Command Syntax
net show config
Command Authority
Operator and Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to the command syntax.
Successful Command Output
Upon successful completion of the command, information on the external network configuration is
displayed.
Command Operation during Abnormal Conditions
If the command does not conform to the required syntax, display the following:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
Example
> net show config
External Network Configuration
Template 1
10GbE data and 1GbE management network
Virtual Management Console IP Address
XXX.XXX.XXX.XXX
Node Specific Parameters
-------------------------------
Node 1:
1GbE Network Physical IP (HP Service Only):
XXX.XXX.XXX.XXX
10GbE Network Physical IP (HP Service Only):
XXX.XXX.XXX.XXX
10GbE Network Virtual Data IP
XXX.XXX.XXX.XXX
Node 2:
1GbE Network Physical IP (HP Service Only):
XXX.XXX.XXX.XXX
10GbE Network Physical IP (HP Service Only):
XXX.XXX.XXX.XXX
10GbE Network Virtual Data IP
XXX.XXX.XXX.XXX
Appliance Wide Parameters
---------------------------------
1GbE subnet mask: XXX.XXX.XXX.XXX
10GbE subnet mask: XXX.XXX.XXX.XXX
net show config 39