Hardware Disable Failover - HP StoreOnce B6000 Series Reference Manual

hardware disable failover

Description of Command Function
Disables the failover feature between nodes which is automatically configured during the initial
automatic configuration of the StoreOnce appliance. HP recommends disabling failover before
rebooting the StoreOnce appliance.
Command Syntax
hardware disable failover [NODEX]
Command Authority
Administrator
Command Object Requirements
NODE X – As an option, this can be used to define an individual file server node. X is a unique
numeric index. NODEX is a label uniquely defining the hardware component. It was assigned
during the initial automatic hardware initialization and configuration and its value resides in the
"node_config" file. A complete list of the NODEX labels can be obtained using the hardware
show node status command (see
node is defined, failover is only disabled for this node.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to the command syntax.
Failover must not already be disabled.
Successful Command Output
Upon successful completion of the command, the following will be displayed:
failover disabled
Command Operation during Abnormal Conditions
1. If the command does not conform to the required syntax, the following is displayed:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
2. If failover is already disabled, the following is displayed:
Command Failed - failover is already disabled
Example
# hardware disable failover node1
failover disabled
20 Alphabetical List of Commands and Details
"hardware show node status" (page 29)). If a file server