System Disable Failover - HP StoreOnce B6000 Series Reference Manual

system disable failover

Description of Command Function
Disables the failover feature on the StoreOnce appliance. It is a direct map to the command
sequence hardware disable failover (see
initial release, this command will only disable failover for the entire appliance. In following releases,
the command will be updated to disable failover for given service sets.
Command Syntax
system disable failover
Command Authority
Administrator
Command Object Requirements
Not applicable – no objects exist within this command.
Command Parameter Requirements
Not applicable – no parameters exist within this command.
Requirements for Command Execution
The command entry must conform to the command syntax.
Failover must not already be disabled.
Successful Command Output
Upon successful completion of the command, the following will be displayed:
failover disabled
Command Operation during Abnormal Conditions
1. If the command does not conform to the required syntax, display the following:
Command Failed - the command does not conform to the required syntax,
SYNTAX, where SYNTAX is the command syntax as described under Command Syntax in this
section.
2. If failover is already disabled for all nodes, the following is displayed:
Command Failed - failover is already disabled
Example
# system disable failover
failover disabled
56 Alphabetical List of Commands and Details
"hardware disable failover" (page 20)). For the