Rebooting The Device; Viewing Logs; Support: Firmware Page; Support: Reboot Page - HP StorageWorks MSL2024 User's And Service Manual

Figure 73 Support: Firmware page
.

Rebooting the device

Use the

Support: Reboot page

(POST) and scan for a new inventory. The RMI web page will refresh itself after a short time delay.
This time should be sufficient to reload the page. However, during a reboot, the connection to the
device may be lost. If the connection is lost, you will have to reload the page manually.
Figure 74 Support: Reboot page
.

Viewing logs

From the Support: Library Logs page
Informational Trace, Warning Trace, Configuration Change Trace, and Standard Trace.
The log entries are displayed in order of most recent to oldest. The format for the log entries is:
YY.MM.DD HH.MM.SS.ss LIB/ERR<80 89 62 40
• YY.MM.DD — the date displayed as Year.Month.Day
• HH.MM.SS.ss — the time displayed as Hour.Minute.Second.Hundredths of a second
• First code — hard or soft error. The code after LIB/ERR (80 in the example) will be 80 or 40. 80
indicates a hard error, 40 indicates a soft error.
• Second code — the main error code (89 in this example). See
list of error codes and recovery procedures.
• Third code — the sub-code (62 in this example). See
for a list of sub-codes.
• Fourth code — sub-code-specific information for factory use only
HP StorageWorks MSL2024, MSL4048, MSL8048, and MSL8096 Tape Libraries User and service
to do a soft reset of the device, which will run the Power On Self Test
you can see the device logs. The available logs are: Error Trace,
Error codes" on page 180 for a
Error sub-code descriptions" on page 196
guide 101