Replacing The Side Panels - Welch Allyn PROPAQ CS Service Manual

86 Repair procedures

Replacing the side panels

The Propaq CS monitor side panels are complete assemblies.
The side panels are sealed to the Rear Chassis with an adhesive gasket. A new gasket is
provided with the new side panel kit.
Removing the right side panel
1. Remove the battery pack
2. Open the monitor
3. Remove the Recharger Board
4. Cut and remove the tie wrap securing the bead connected to the side panel.
5. Remove the two right side panel clamps by inserting the end of the flat blade
screwdriver under the clamp and gently rotating the blade to loosen the clamp. Then
slide the clamp out.
6. Press the side panel out of the Rear Chassis. There is an adhesive gasket around the
side panel which requires considerable force to separate. Do not pry against
components.
("Removing the single battery pack"
("Opening the monitor"
("Replacing the Recharger Board"
INSERT SMALL SCREWDRIVER
BETWEEN PLASTIC AND CLAMP
TO RELIEVE TENSION AGAINST
PLASTIC
Welch Allyn Propaq CS Vital Signs Monitor
on page 66).
on page 68).
on page 83).
0696-42