Table of Contents
Advertisement
Service Manual
Replacing the Side Panels
The Propaq Encore side panels are complete assemblies.
The side panels are sealed to the rear chassis with an adhesive gasket. A new gasket is
provided with the new side panel kit.
Removing the Right Side Panel
1.
Remove the battery pack
2. Open the monitor
3. Remove the Recharger board
4. Cut and remove the tie wrap securing the bead connected to the side panel.
5. Remove the two right panel clamps by inserting the end of the flat blade screwdriver
under the clamp and gently rotating the blade to loosen the clamp. Then slide the
clamp out.
6. Press the side panel out of the rear chassis. There is an adhesive gasket around the
side panel which requires considerable force to separate. Do not pry against
components.
Removing the Left Side Panel
1.
Remove the battery pack
2. Open the monitor
3. Remove the Recharger board
4. Remove the U-shaped clamp that secures the left side panel assembly by inserting a
small screwdriver between the clamp and plastic and the end of another flat blade
screwdriver under the clamp and gently rotating the blade to loosen the clamp. Then
slide the clamp out.
("Replacing the Battery Pack"
("Opening the Monitor"
("Replacing the Recharger Board"
INSERT SMALL SCREWDRIVER
BETWEEN PLASTIC AND CLAMP
TO RELIEVE TENSION AGAINST
PLASTIC
("Replacing the Battery Pack"
("Opening the Monitor"
("Replacing the Recharger Board"
Repair Procedures
on page 52).
on page 55).
on page 72).
0696-42
on page 52).
on page 55).
on page 72).
75
Advertisement
Table of Contents
