Welch Allyn PROPAQ CS Service Manual page 32

28 Functional verification
• Masimo-compatible SpO
• Compatible adult SpO
• BIO-TEK Index 2 Series SpO
equivalent).
1. Turn on power to the SpO
2. Connect the SpO
3. Apply the SpO
4. Set the simulator manufacturer type ("MAKE") to Masimo.
5. Set the simulator output to SpO
(with no motion artifact selected).
Confirm that the monitor displays SpO
moving.
Confirm that the displayed saturation is 94% ±4 counts, and the displayed pulse rate
is 60 ±4 bpm.
6. Disconnect the sensor from the simulator and cable, and disconnect the SpO
Functional verification for Nellcor SpO
This functional verification procedure helps to confirm the proper operation of the Nellcor
Pulse Oximetry option installed in the Propaq monitor. This procedure supports the
requirements of routine preventive maintenance. No monitor disassembly is required to
perform this procedure.
You will need the following equipment to perform this procedure.
• Nellcor-compatible adult SpO2 finger sensor
• BIO-TEK Index 2 Series SpO
equivalent).
1. Turn on power to the SpO
2. Connect the SpO2 sensor to the monitor and apply to the SpO2 simulator optical
finger.
3. Set the simulator manufacturer type ("MAKE") to Nellcor.
4. Set the simulator output to SpO
(with no motion artifact selected).
Confirm that the monitor displays SpO
moving.
Confirm that the displayed saturation is 94% ±4 counts, and the displayed pulse rate
is 60 ±4 bpm.
5. Disconnect the sensor from the simulator.
Sensor compatibility
Some sensors are not compatible with the particular Nellcor processing board installed in
the Propaq. To determine which pulse oximetry optional processing board is installed in
the Propaq, find the option number on the back label of the Propaq, then refer to table
cable.
2
sensor for finger.
2
Simulator with optical finger for sensor connection (or
2
simulator.
2
cable to the monitor and the SpO
2
sensor to the SpO simulator optical finger.
2 2
saturation 94% and pulse rate 60 beats per minute
2
2
Simulator with optical finger for sensor connection (or
2
simulator.
2
saturation 94% and pulse rate 60 beats per minute
2
Welch Allyn Propaq CS Vital Signs Monitor
sensor.
2
data and the pulse amplitude indicator is
2
data and the pulse amplitude indicator is
2
cable.
2