Welch Allyn PROPAQ CS Service Manual page 14

10 Overview
The Propaq CS monitor contains software routines that make the Functional Verification
and Calibration procedures quicker and easier. You access these routines through the
Service Menus as indicated in each of the procedures.
The figure below shows the hierarchy of the Service Menus once you enter the top level
Service Menu.
The procedures in this manual indicate which buttons to push by separating each button
menu name with the (>) character. For example, to access the Service Menu, the
procedures would indicate for you to press SETUP > MORE > MORE > SERVICE > YES,
which means you press the SETUP button, then the MORE button, then the MORE
button, then the SERVICE button, and finally the YES button.
Note
service menusservice menus
To access the Service Menu, from the Main Menu press: SETUP > MORE >
MORE > SERVICE > YES.
NIBP
TEST
PUMP
TEST
TEMP
1 2.4 GHz radio card TEST
only.
2
No function on 5
GHz radio card
CONTROLLER
TEST
LOOP
TEST
MAIN
CAL
SETTINGS
KEY 0
NEXT
3 Software version
3.6x only.
The figure illustrates the Service Menu functions. Some of these functions are
not available if you do not have the appropriate option.
IBP SpO2
TEST TEST
AUTO NIBP
PUMP CAL
PIXEL NET
1, 2
TEST TEST
MEMORY WLAN
TEST TEST
OUT
TEST
MAIN SIDE
TEST CAL
SCREEN SYSTEM
CAL
KEY 1 KEY 2
CHANGE
Welch Allyn Propaq CS Vital Signs Monitor
CO2 MORE
TEST
ZERO PREVIOUS
MENU
PCMCIA MORE
1
TEST
PREVIOUS
MENU
PREVIOUS
MENU
SIDE PREVIOUS
TEST MENU
MORE
KEY 3 KEY 4
ALL PREVIOUS MENU
3
ALARM