With The Tm-L90 Peeler Specification - Epson TM L90 Technical Reference Manual

2.10.2 With the TM-L90 peeler specification

With the TM-L90, the paper loading method differs depending on whether peeling issuing or
continuous issuing is used. They are explained as follows.
Paper setting with peeling issuing
1. Press the peeler cover open lever, and open the peeler cover.
2. Press the roll paper cover open lever, and open the roll paper cover.
3. If there is a roll paper with little paper remaining inside the TM-L90 peeler, take it out.
4. Check that the printer is on. If it is not on, turn it on.
5. Put a new roll paper in the TM-L90 peeler. Make sure that the roll paper is oriented as
shown in the following figure.
6. Slide the mode switch to the right (peeling issuing mode).
2-42 Setup Rev. B