Starting The Memory Switch Setting Mode - Epson TM L90 Technical Reference Manual

2.8.2 Starting the Memory Switch Setting mode

Use the following procedure to start the memory switch setting mode.
1. For the TM-L90, open the roll paper cover. For the TM-L90 with Peeler, open the peeler
cover and the roll paper cover.
2. Load roll paper.
3. Turn on the power while pressing FEED inside the printer. Keep pressing FEED until the
POWER, ERROR, and PAPER OUT LEDs all come on. The figure shows the TM-L90.
The location of the FEED button (inside the roll paper cover)
4. While the POWER, ERROR, and PAPER OUT LEDs are on, press FEED inside the printer
twice.
5. Close the cover. The printer will print out a guidance for the memory switch setting mode
and then enter the memory switch setting mode.With the peeling issuing mode, after closing
the roll paper cover, the PAPER OUT LED flashes. After inserting the label into the peeler
path, press FEED.
6. Follow the guidance to use the mode. (Refer to the flowchart "Operating procedure of
Memory Switch Settings" on page 2-27)
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
Paper FEED button
(inside the printer)
Setup 2-25