2.8.1 Items that can be set in the memory switch setting mode
The items that can be set in the memory switch setting mode are as follows.
❏ Autocutter settings (TM-L90 only)
❏ Paper selection / print density
❏ Serial communication conditions
•
Baud Rate Setup
•
data length, handshake, Parity
❏ Communication related
•
Receive buffer size
•
Receive error handling
•
BUSY conditions
❏ Interface reset signal
•
Parallel interface #31 pin: Selecting reset signal
•
Serial interface #25 pin: Selecting reset signal
•
Serial interface #6 pin: Selecting reset signal
❏ Paper width selection
❏ FEED button operational settings (TM-L90 peeler specification only)
❏ Label Settings
•
Maximum length of automatic paper measurement
•
With or without the function of feeding paper to the print starting position at power on
•
Recovery from paper layout error
Note:
Turning off the power supply in the memory switch setting mode clears all settings. After performing the
complete operation, turn off the power using the correct procedure.
2-24 Setup
Rev. B