Tm Setup Items (Summary) - Epson TM L90 Technical Reference Manual

7. Close the roll paper cover.
The paper information in the NV memory in the printer is cleared, and to indicate that
the layout information is cleared, the printer automatically feeds paper.

2.11 TM Setup Items (Summary)

Items of TM setup are shown below; refer to the table below for information about setting items
and adequate switches.
Item
Autocutter Setting cut type
Paper width When changing paper
width
Roll paper near- Adjusting detector of near
end adjusting end roll paper
Enable/disable Power switch can be
power switch (*) invalidated.
Select for serial Serial communication
communication settings can be made
condition either by DIP switch or
memory switch. If DIP
switch 2 is on, the DIP
switch setting is read; if DIP
switch 2 is off, the memory
switch setting is read.
Set for serial Handshake, Bit length,
communication presence of Parity check,
condition Parity select, Baud rate
select.
Rev. B
Description Mechanic
Refer to
"Autocutter
settings (TM-
L90 only)" on
page 2-24
See "Setting
Roll Paper
Width" on
page 2-19
See
"Adjusting
Roll Paper
Near-End
Detection
Position" on
page 2-6
TM-L90/TM-L90 with Peeler Technical Reference Guide
Setting method
DiP switch Memory switch
-- Switching Enable/
Disable
-- Memory switch
--
-- DIP switch
1-1 "DIP
Switch
Settings"
on page
2-21
-- DIP switch
1-2 "DIP
Switch
Settings"
on page
2-21
-- DIP switch Memory switch
1-3 to 1-8
"DIP
Switch
Settings"
on page
2-21
Setting Memory
switch
See "Items that can
be set in the
memory switch
setting mode" on
page 2-24
See "Items that can
be set in the
memory switch
setting mode" on
page 2-24
-- --
-- --
-- --
See "Items that can
be set in the
memory switch
setting mode" on
page 2-24
Setup 2-51