Epson TM L90 Technical Reference Manual page 63

MSW8
Bit Function
1 Means of recovery from paper layout error
2 Paper layout error recovery means
3 PAPER OUT LED behavior at paper near-end
occurrence
4 Select maximum length for automatic
measurement of paper
5 Insert left and right margins to barcode
6 Feeding paper to the print starting position
at power on
7 Reserved
8 Printer cover open during operation
If [Msw8-1] is OFF, the paper is determined automatically if the printer recovers from the paper layout error.
Furthermore, the results of automatic paper determination are overwritten if the settings for paper layout are
already saved in the NV memory.
If [Msw8-2] is OFF, the paper is determined automatically if the printer recovers from the paper layout error.
Furthermore, the results of automatic paper determination are overwritten if the settings for paper layout are
already saved in the NV memory.
The [Msw 8-4] setting influences initialization at power-on when "label paper" or "receipt paper with black mark" is
specified for the paper layout. Refer to "Setting Paper Layout" on page 2-45 for the paper layout.
When [Msw 8-6] is set to "Feeding paper to the print starting position at power on is disabled", the printer does not
execute the operation of feeding paper to the print starting position at power on (the printer executes the
operation when its cover is opened and closed). Hence, the user should note the following points since the printer
operates on the assumption that the paper has already been fed to the print starting position at power on.
a)Turn off the power supply after feeding of paper to the print starting position.
b)Do not open the cover while power is off.
c)If you have opened the cover with power off, turn power on, then open and close the cover once before
starting printing, and perform the operation of feeding paper to the print starting position.
If the print starting position has not been set at power-on, the printing position of the first sheet may shift, or a paper
layout error may occur.
*: Factory setting
Customized values
Item
Selection of user NV memory
capacity
Selection of NV graphics memory
capacity
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
Value
0 (OFF)
Recovery by pressing FEED
Recovery by pressing FEED
On *
160 mm
Not inserted *
Enabled *
Fixed to OFF
Automatically recoverable
error
Value
1 KB * 64 KB
128 KB 192 KB
None 64 KB
128 KB 192 KB
256 KB 320 KB
384 KB *
1 (ON)
No recovery by pressing
FEED
No recovery by pressing
FEED
Off
300 mm
Inserted
Disabled
--
Recoverable error *
(Recovered by error
recovery command)
Setup 2-39