❏ Interface Reset Signal
Pins #25 and #6 of the serial interface board unit (UB-S01/02) are input pins for the reset signal.
This item is used to "Enable (acknowledge)" or "Disable (not acknowledge)" input of the reset
signal from one of these pins. Press the FEED button the number of times required to select the
desired Interface reset signal setting.
Press FEED button
0 times:
1 time:
2 times:
3 times:
4 times:
5 times:
6 times:
7 times:
8 times:
9 or more times:
❏ Selection of Paper width
Select Paper width by pressing the FEED button the number of times required.
Press FEED button
0 times:
1 time:
2 times:
3 times:
4 times:
5 times:
6 or more times:
Note:
When using label roll paper that can't be selected in the memory switch setting mode within the range
from 38 mm to 80 mm, configure the paper width using any one of 3 control systems: OPOS, Advanced
Printer Driver, or ESC/POS. The brief introduction of the control systems is in "Introduction of
Control Methods" on page 4-1.
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
Setting to select
Parallel interface #31 pin
No change
Enable
Disable
No change
Paper width
No change
38mm
58mm
60mm
70mm
80mm
No change
Serial interface #25 pin
Disable
Enable
Disable
Enable
Serial interface #6 pin
Disable
Enable
Disable
Enable
Disable
Enable
Disable
Enable
Setup 2-31