Autocutter Settings (Tm-L90 Only) - Epson TM L90 Technical Reference Manual

2.5 Autocutter settings (TM-L90 only)

The TM-L90 has an autocutter attached for cutting the paper. The autocutter can perform 2 cuts,
"partial cut," in which a small part is left uncut on the left edge, and "full cut" (default setting), in
which the paper is cut completely. By adjusting the attachment position of the cutter unit, you
can select between "partial cut" and "full cut."
Note:
You can't configure the autocutter setting (Partial cut/Full cut) through a software command.
You can't change from partial cut setting to full cut setting after using the printer with partial cut
setting. Since the partial cut doesn't use the tip of the blade, it might have deteriorated. Contact the
nearest EPSON service center if you'd like to do the above change.
To disable the autocutter, change the memory switch (MSW2-2) settings. (Refer to "Setting Memory
Switches" on page 2-23).
Performing full cut without the paper exit guide when the printer installed horizontally may cause a
double-cut, paper jam or autocutter error because a cut sheet may drop in the paper path. Be sure to attach
the paper exit guide when performing a full cut in the horizontal installation. (Refer to "Instructions for
Installation" on page 2-3 for instructions on attaching the guide.)
1. Turn off the power.
2. Press the roll paper cover open lever, and open the roll paper cover.
3. Push the body case outward (in the direction of the 2 arrows) and remove the cutter cover.
2-16 Setup
cutter cover
Rev. B