Table of Contents
Advertisement
For the TM-L90, when changing the way of installation, you need to adjust the following items:
•
Control panel label used for horizontal installation
•
The location of the Roll Paper Near-End Detector
The following figure shows the TM-L90 placed both vertically and horizontally.
When you install the printer horizontally, attach the control panel label as shown in the
illustration below.
Note:
To hang the printer on the wall, see the Wall Hanging Bracket Set Installation Manual provided with the
WH-10 for instructions.
When you use TM-L90 horizontally, peel off the backing sheet of the paper exit guide and attach
it as shown below to prevent cut paper from falling inside the printer after paper is cut by the
autocutter.
2-4 Setup
Control panel label
Rev. B
Hide quick links:
Advertisement
Table of Contents
