Epson TM L90 Technical Reference Manual page 61

Customized values
Selection of the number of parts for
the thermal head energizing
Selection of print density
Selection of print color
Selection of print speed
Black density for two-color printing
Note:
The maximum print speed is available for only the one-part energizing mode. However, if the print duty is
too high in the one-part energizing mode, the printer will automatically reduce the printing speed.
The four-part energizing mode reduces power consumption.
The print width can be set in 43 ways with 1 mm pitches in the range from 38 mm to 80 mm. However, it
cannot be set in the range from 71 mm to 79 mm.
*: Factory setting
Serial Communication condition
Item
Baud rate
Parity
Flow Control
Data Length
Note:
The memory switch serial communication conditions are applied only if the DIP switch 2 setting is "set
with memory switch."
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
One-part energizing *
Two-part energizing
Three-part energizing
Four-part energizing
70% 75%
80% 85%
90% 95%
100% * 105%
110% 115%
120% 125%
130% 135%
140%
Single color *, two colors
Speed level 1 (max. 26 mm/s)
Speed level 2
Speed level 4
Speed level 6 (max. 120 mm/s) *
Speed level 7
Speed level 9 (max. 150 mm/s)
Low, normal *, high
Option
115200 bps 9600 bps
57600 bps 4800 bps
38400 bps 2400 bps
19200 bps
None/ Odd/ Even
DTR/DSR Control
XON/XOFF Control
7-bit/8-bit
Speed level 3
Speed level 5
Speed level 8
Setup 2-37