Table of Contents
Advertisement
d) User defined code page (Page 255 (space page))
e) Area of command default values specified by users
By changing those values, you can customize your printer.
Note the following when writing to and erasing NV memory.
❏ The following restrictions apply when performing nonvolatile memory operations
(including data store and delete).
•
The paper feed switch must not be used to feed paper.
•
No real time command can be executed.
•
The ASB status will not be sent, even when the ASB function in ESC/POS command is
set to enable.
❏ The printer will sometimes enter the Busy state when data is being written to nonvolatile
memory. It is important not to send data from the host computer while the printer is in the
Busy state as it will be incapable of processing any received data.
❏ Frequent use of the functions for defining data to and deleting data from nonvolatile
memory can damage the memory. As a rule, in using the various commands to write to NV
memory, avoid writing more than an average of 10 times per day.
5.5 Customizing Printer
You can customize your TM printer by changing memory switches and the command default
value and saving the data onto the NV (nonvolatile) memory. Refer to the next section.
5.5.1 Printer initial setting up
Printer initial setting up can be made by memory switches and character code page. Refer to
page 2-23 for details of memory switches.
5.5.2 Changing command default values
You can customize your TM by changing the command default value and save the data onto the
nonvolatile memory.
5.5.3 Using the NV Memory
There is free area in NV memory for user can use. You can use this free area as memo, write
other character information or multipurpose. The data is enabled if you turn off the power. Refer
to the "ESC/POS Application Programming Guide" how to read and write.
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
ESC/POS Command-Related Information 5-3
Hide quick links:
Advertisement
Table of Contents
