Appendix E Maintenance; Cleaning The Autocutter (Tm-L90 Only - Epson TM L90 Technical Reference Manual

Appendix E
Maintenance
E.1 Cleaning the autocutter (TM-L90 only)
If label paper adhesive has stuck to the autocutter, it may dull the cutting edge. In such a case,
clean the cutter blade using the following procedure.
1. Turn off the power.
2. Disconnect the printer from the power connector.
3. Open the roll paper cover.
Note:
If the roll paper cover will not open, take action in accordance with the troubleshooting of the
autocutter (page F-8).
4. As shown below, remove the adhesive residues accumulated on the cutter blade on the roll
paper cover side with a cutter knife or similar tool.
Rev. B
TM-L90/TM-L90 with Peeler Technical Reference Guide
Adhesive adheres on cutter blade
Maintenance E-1