Starting The Memory Switch Setting Mode; Ending Memory Switch Setting Mode - Epson TM-J7100 Developer's Manual

Confidential
• Data processing for receiving error (Msw1-4)
❏ Automatic line feed (Msw 1-5)
❏ Interface reset signal (Msw1-7, Msw1-8)

Starting the memory switch setting mode

Use the following procedure to start the memory switch setting mode.
1. Open the roll paper cover.
2. Turn the power on while pressing the paper FEED button until the POWER, ERROR, and
PAPER OUT LEDs are all on.
3. Press the FEED button twice while POWER, ERROR, and PAPER OUT LEDs are on.
4. Close the roll paper cover.
The printer is now in the memory switch setting wait mode.
5. Press the FEED button. The printer prints the enabled settings of the memory switches and
instructions.
6. Follow the instructions to make the switch settings.

Ending memory switch setting mode

Once the setting is performed, the contents of the setting are stored. Then the printer initializes.
When initialization is finished, the printer returns to normal operating mode.
2-8 Adjustments and Settings Rev. A