Table of Contents
Advertisement
Status sheet button
The first time you use the interface card after installing or
reinstalling it, turn on the printer while holding down the status
sheet button for about five seconds to initialize the interface card.
Before you start configuring the interface card, be sure to press
the status sheet button on the interface card for about three
seconds to print a status sheet. A status sheet shows important
information such as the current configuration, the serial number,
and the MAC address. You will need this information to configure
the interface card.
You cannot print a status sheet if the printer has started printing,
if it is off-line, or if it is not ready to print.
Note:
If the printer does not print a status sheet, make sure that the printer is
on-line and no print jobs are being processed, then wait a minute before
trying again. If it still does not print a status sheet, turn the printer off,
wait until the status lights go out, and then turn it on again.
c
Caution:
After turning off the printer, wait until the status lights go out
before turning it back on; otherwise the interface card may not
work correctly.
Network connectors
The interface card can detect which kind of cable is attached. You
do not need to make any hardware or software settings to specify
the cable type. However, you must not attach more than one cable
at a time.
10BASE-2 (C82362 only)
Connect the Ethernet thin coaxial (10BASE-2) cable to the BNC
connector on the interface card using the supplied Y-connector.
1-3
Getting Started
1
Advertisement
Table of Contents
