Table of Contents
Advertisement
Configuring the Interface Card Using EpsonNet
WinAssist
If you want to configure the interface card using EpsonNet
WinAssist from Windows environment, follow the steps below.
1. Turn on the printer with the interface card.
2. Start EpsonNet WinAssist.
Windows 98/95/2000/NT 4.0: Click Start, point to Programs,
EpsonNet WinAssist, then click EpsonNet WinAssist.
Windows NT 3.51: Double-click the EpsonNet WinAssist icon
in the EpsonNet WinAssist group.
3. Select the printer you want to configure from the list, then
click Configuration or double-click the printer.
Note:
If you have connected more than one printer with the same type
of interface card to the network, you can distinguish between
the cards by the MAC address on the status sheet or the sticker
on the interface card.
If the IP address is set to the default IP address, the printer model
may not appear.
Using the Interface Card with Macintosh
4
4-5
Advertisement
Table of Contents
