Epson C82362 Administrator's Manual page 257

Unable to make settings using EpsonNet WebAssist.
Cause
You haven't set the IP
address for the interface
card.
Unable to set the IP address using the arp/ping commands.
Cause
The network cable may be
disconnected.
The address of the router is
set as the default gateway.
PING is not on.
What to do
Set the IP address for the interface
card using EpsonNet WinAssist,
MacAssist, or the ping command, as
described in Chapter 2 . You can check
the IP address on a status sheet.
What to do
Connect the network cable. Also, check
the network environment.
Set the IP address of your computer for
the default gateway temporarily. After
setting the IP address, return the IP
address to the original value.
Check the Set by PING check box in the
TCP/IP menu of EpsonNet WinAssist.
Select ON for Set by PING in the TCP/
IP screen of EpsonNet WebAssist.
Troubleshooting
14
14-3