Table of Contents
Advertisement
HercuLink
Calibration
Calibration
Input Calibration
Step
1
Prepare for calibration by performing the steps shown in your actuator maual's calibration
section, then return here.
2
From the Home page, select the Calibration prompt.
3
Select the input type to be calibrated. This calibration procedure can be used for each input
type. Note: "Input" does not appear if input type is RSP (remote setpoint).
4
Connect a variable DC voltage source to the input terminals.
5
Select the Input prompt. The functionality of each button is described below:
Setup – Has no functionality in the input calibration procedure.
Function – Sequences you through the calibration states.
Auto /Man - Has no functionality in the input calibration procedure.
Display - Has no functionality in the input calibration procedure.
Increment - Has no functionality in the input calibration procedure.
Decrement - Has no functionality in the input calibration procedure.
Close – Exits from the input calibration.
8
Action
HercuLink™ - User Manual
Release 3
8/02
Advertisement
Table of Contents
