Environmental Requirements - Smart Technologies SMART Board 600i3 Configuration And User's Manual

10 | CH A P T E R 2 – I NSTAL LI NG YOUR S MAR T BOAR D 60 0I3 OR SB D6 00I 3
I N T E R A C T I V E W H I T E B O A RD S Y S T E M

Environmental Requirements

Before installing your SMART Board 600i3 or SBD600i3 interactive whiteboard
system, review the following environmental requirements.
CAUTION
• Do not operate this unit immediately after moving it from a cold location
to a warm location. When the unit is exposed to such a change in
temperature, moisture could condense on the lens and crucial internal parts.
Allow the system to stabilize to room temperature before operation to prevent
possible damage to the unit.
• In a location over 6000' (1829 m) altitude, the air is thin and cooling efficiency
is reduced, so use the projector with the fan mode set to High.
• Do not place the unit in hot locations, such as near heating equipment.
Doing so could cause a malfunction and shorten the life of the projector.
IMPORTANT
Using the UF55/UF55w projector system near a TV or radio could cause
interference to the images or sound. If this happens, move the TV or radio away
from the projector.