Environmental Requirements - Smart Technologies SMART Board 800ixe-SMP Configuration And User's Manual

I M P O R T A N T I N F O R M A T I O N

Environmental requirements

Before you install your SMART Board 800 interactive whiteboard system with appliance, review the
following environmental requirements.
Environmental
requirement
Operating temperature
Storage temperature
Humidity
Water and fluid
resistance
Dust
Electrostatic discharge
(ESD)
Cables
Conducted and radiated
emissions
vi
Parameter
41°F to 95°F (5°C to 35°C) from 0' to 6000' (0 m to 1800 m)
l
41°F to 86°F (5°C to 30°C) from 6000' to 9800' (1800 m to 3000 m)
l
-4°F to 104°F (-20°C to 40°C)
l
30% to 80% relative humidity, non-condensing
l
Intended for indoor use only. Doesn't meet any salt-spray or water
l
ingress requirements.
Don't pour or spray liquids directly onto your interactive whiteboard,
l
the projector or any of its sub-components.
Intended for use in office and classroom environments. Not for
l
industrial use where heavy dust and pollutants can cause
malfunctions or impaired operation. Periodic cleaning is required in
areas with heavier dust. See Cleaning the projector on page 45 for
information on cleaning the SMART UX60 projector.
Designed for pollution degree 1 (P1) as per EN61558-1, which is
l
defined as "No pollution or only dry non-conductive pollution".
EN61000-4-2 severity level 4 for direct and indirect ESD
l
No malfunction or damage up to 8kV (both polarities) with a
l
330 ohm, 150 pF probe (air discharge)
Unmated connectors meet no malfunction or damage up to 4kV
l
(both polarities) for direct (contact) discharge
All SMART Board 800ixe-SMP interactive whiteboard system with
l
appliance cables should be shielded to prevent potential accidents
and degraded video and audio quality.
EN55022/CISPR 22, Class A
l