Replacing The Projector Lamp Module - Smart Technologies SMART Board 600i3 Configuration And User's Manual

61 | CH A P T E R 8 – R E P L A C I NG Y O U R U F 5 5 / U F 5 5 W P R O J E C T O R L A M P

Replacing the Projector Lamp Module

After you remove the lamp from the boom, follow these instructions to replace
the lamp.
To remove and 1. Wait at least 30 minutes for the projector to completely cool down.
replace the lamp
2. Pull up the outer lamp cover with your finger.
3. Remove the outer lamp cover and keep it in a safe place.
4. Loosen the two screws on the inner lamp module with a Phillips No. 2 screwdriver.
The screws remain captive with the lamp module.