Smart Technologies SMART Board 600i3 Configuration And User's Manual page 28

To adjust the
projector alignment
16 | CH A P T E R 2 – I NSTAL LI NG YOUR S MAR T BOAR D 60 0I3 OR SB D6 00I 3
I N T E R A C T I V E W H I T E B O A RD S Y S T E M
1. If the bottom edge of the projected image is smaller than the top edge of the
projected image, and the sides of the projected image slope inward toward the
bottom of the projected image, tilt the projector down or raise the projector's
mounting boom to lower the image. Turn the center hex screw at the base of the
boom counter-clockwise using a 6 mm hex key (not included) to raise the boom.
2. If the bottom edge of the projected image is larger than the top edge of the
projected image, and the sides of the projected image slope outward toward the
bottom of the projected image, tilt the projector up or lower the projector's
mounting boom to raise the image. Turn the center hex screw at the base of the
boom clockwise using a 6 mm hex key (not included) to lower the boom and tilt
the projector forward and backward.
NOTE
The entire projected image may increase slightly in size during this process,
and more at the bottom of the projected image than at the top.
Center Hex Screw
Projector Boom