Environmental Requirements - Smart Technologies SMART Board 800i5e-SMP Configuration And User's Manual

I M P O R T A N T I N F O R M A T I O N
Service
W A R N I N G
There are no user-serviceable parts inside the pen tray. Only qualified personnel should
l
disassemble the pen tray's printed circuit boards, and this procedure must be done with
proper electrostatic discharge (ESD) protection.
C A U T I O N
Do not adjust any settings in the service menu other than those listed in the following
l
procedures. Changing other settings might damage or affect the operation of your projector
and may invalidate your warranty.
When transporting your SMART product, repack it with as much of the original packaging as
l
possible. This packaging was designed with optimal shock and vibration protection.
If your SMART product requires replacement parts, make sure the service technician uses
l
replacement parts specified by SMART Technologies or parts with the same characteristics
as the original.

Environmental requirements

Before you install your SMART Board 800 interactive whiteboard system with appliance, review the
following environmental requirements.
Environmental
requirement
Operating temperature
Storage temperature
Humidity
Water and fluid
resistance
vi
Parameter
41°F to 95°F (5°C to 35°C) from 0' to 6000' (0 m to 1800 m)
l
41°F to 86°F (5°C to 30°C) from 6000' to 9800' (1800 m to 3000 m)
l
-40°F to 122°F (-40°C to 50°C)
l
30% to 80% relative humidity, non-condensing
l
Intended for indoor use only. Doesn't meet any salt-spray or water
l
ingress requirements.
Don't pour or spray liquids directly onto your interactive whiteboard,
l
the projector or any of its sub-components.