Using Your Uf55/Uf55W Projector; Using Your Remote Control; Menu Options - Smart Technologies SMART Board 600i3 Configuration And User's Manual

To adjust settings using
the remote control
31 | CH A P T E R 4 – U S I NG Y O U R S M A R T B O A R D 6 00 I3 O R S B D 6 0 0 I 3 I NT E R A C T I V E
WH ITE BOARD S YS T E M

Using Your UF55/UF55w Projector

The UF55/UF55w projector includes two LED indicators. Refer to the Power and
Temperature status indicators on the projector's underside to determine the projector
status and to troubleshoot unexpected behavior.

Using Your Remote Control

The UF55/UF55w projector system remote control enables you to open on-screen
projector menus and change the projector settings. You can also use the remote
control's ON/IDLE button or the ECP power button to turn the projector system on
or off.
NOTE
Ensure that you remove the remote control battery's plastic casing before use.
You can access the adjustment options through the remote control's Menu button.
1. Press the left or right
2. Press the up or down
3. Press the left or right
4. Press enter when you're satisfied with the settings.

Menu Options

NOTE
The menu heading at the top of all settings is SMART UF55 Settings.
Menu
Settings
Heading
Image Display
Adjustment Mode
Brightness
Contrast
Frequency
Tracking
button to access a menu option.
button to select the relevant menu option.
button to move between menu option settings.
Description
Adjusts the display output to sRGB, Bright Room,
Dark Room, User, and SMART Presentation.
Adjusts projector brightness from 0 to 100.
Adjusts projector contrast from 0 to 100.
Adjusts the frequency of the projected image from -5
to 5. Default is set to 0. Applies to the VGA inputs
only.
Synchronizes your display timing with your
computer's graphic card from 0 to 31. Applies to the
VGA inputs only.