Performing An Image Alignment - Smart Technologies SMART Board 600i3 Configuration And User's Manual

Interactive whiteboard system
Table of Contents

Advertisement

To perform an initial
image alignment
15 |
CH A P T E R 2 – I NSTAL LI NG YOUR S MAR T BOAR D 60 0I3 OR SB D6 00I 3
I N T E R A C T I V E W H I T E B O A RD S Y S T E M

Performing an Image Alignment

Use this procedure to obtain a rectangular image that's slightly smaller than your
interactive whiteboard's screen.
NOTES
Project a computer image (set to the proper resolution) while performing the
following steps. If you don't have a computer, use the projector's default blue
background so that you can see the fully projected image clearly.
SMART doesn't recommend adjusting digital keystoning within the projector.
Instead, use the mechanical adjustment described below.
1. Align the top of the projected image so that it's parallel with the top edge of your
interactive whiteboard's surface.
2. Loosen the large wingnut on the top of the ball joint to allow movement of the
projector as needed.
IMPORTANT
Do not loosen the wingnut too much or the projector will not hold the
adjustments.
3. Tilt the projector left or right, up or down, or from side to side, until the top edge of
the projector image is parallel with the top edge of your interactive whiteboard.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sbd600i3Sbd600 seriesUf55Uf55wSmart board 600 series

Table of Contents