Removing The Projector From The Boom - Smart Technologies SMART Board 600i3 Configuration And User's Manual

To remove the projector
from the boom
59 | CH A P T E R 8 – R E P L A C I NG Y O U R U F 5 5 / U F 5 5 W P R O J E C T O R L A M P

Removing the Projector from the Boom

Before you can replace the projector lamp, you must remove the projector from
the boom.
NOTE
Ensure that you remove the projector's plastic lens cover.
WARNING
Two people are required to remove and replace the projector.
1. Turn off the projector by pressing the remote control's power
2. Wait for the projector to cool by allowing the fan to shut down completely,
and then disconnect the power cord from the wall.
3. Disconnect all of the cables from the projector. For details on removing the cable
cover, see the UF55/UF55w Projector User's Guide
4. While firmly holding the projector with your hand, and without applying pressure
or weight to the projector boom, remove the screw holding the cover in place,
and then remove the cover. Place the screw in a safe place.
button.
(document 133564).