Sd/Sdio Setup - Motorola MC70 Integration Manual

Card Cover Removal
Figure 2-2
Insert the card with the card contacts facing down and the cut corner on the right, until you feel a click.
3.
Replace the housing cover and secure with the screws.
4.
To remove an MMC/SD card:
Power off the EDA.
1.
Remove the card cover at the top of the EDA by loosening the screws and lifting the cover out of the slot.
2.
Using the stylus, press and release the card to eject it.
3.
Remove the card from the card slot.
4.
Replace the card cover.
5.

SD/SDIO Setup

NOTE On devices with AKU 3.2 and higher, the SDSwitch Settings application is installed.
Use the
SDSwitch Settings
Tap >
1. Start Settings
SDSwitch Settings Window
Figure 2-3
In the
2. SD Driver Mode
Tap the
SDIO Mode
application to indicate the type of card installed in the SD slot.
> tab > icon.
System SDSwitch
section, select the type of SD card installed in the SD slot.
radio button if an SDIO card is installed in the SD slot.
Accessories 2 - 3