Ip Mode - Motorola MC70 Integration Manual

7 - 16 MC70 Integrator Guide
Key Entry Page
If you select either
check box was selected in the
Passkey
dialog box will be shown only if the authentication is set to
Enter the 40-bit or 128-bit keys into the fields.
1.
Tap .
2. Next
40-Bit WEP Keys Dialog Box
40-Bit and 128-Bit WEP Keys Dialog Boxes
Figure 7-22
Passkey Dialog
When you select
None
checking the
Use PassKey
checkbox is only available if the authentication is None.
When you select None as an authentication and
cannot enter a passkey if the encryption is
When you select
None
cannot enter a passkey if the encryption is
Passkey Dialog Box
Figure 7-23
Tap . The
Next

IP Mode

IP Mode
Use the dialog box to configure network address parameters: IP address, subnet, gateway, DNS, and
IP Mode
WINS.
or
40-Bit WEP 128-Bit WEP
Encryption
128-Bit WEP Keys Dialog Box
as an authentication and
check box. The user is prompted to enter the passkey. For WEP, the
TKIP
as an authentication and
AES
dialog box displays.
the wizard proceeds to the key entry dialog box unless the
dialog box (see Figure 7-21 on page
.To enter the key information:
None
as an encryption, you can choose to enter a passkey by
WEP
as an encryption, you must enter a passkey. The user
TKIP
and the authentication is anything other than
as an encryption, you must enter a passkey. The user
AES
and the authentication is anything other than
Use
7-14). The
Key Entry
Use PassKey
.
None
.
None