To accomplish this, for small periods of time, the EDA or accessory alternately enables and disables battery
charging to keep the battery at acceptable temperatures. The EDA or accessory indicates when charging is
disabled due to abnormal temperatures via its LED. See
Wall Mount Bracket
Use the optional Wall Mount Bracket to mount a four slot cradle to a wall. To attach the Wall Mount Bracket:
Use the Wall Mount Bracket as a template and mark the locations of the four mounting screws.
1.
NOTE Use fasteners appropriate for the type of wall and the Wall Mount Bracket mounting slots. The Wall Mount
Bracket mounting slots are designed for a fastener with a #8 pan head.
Mount the fasteners to the wall. The screw heads should protrude about a half of an inch from the wall.
2.
Slip the Wall Mount Bracket over the screw heads and slide the bracket down over the screw heads.
3.
Tighten the screws to secure the bracket to the wall.
4.
Mounting Slot
Wall Mount Bracket
Figure 2-14
To mount a four slot cradle:
Screw the supplied fasteners into the bottom of the four slot cradle. The screw heads should protrude
1.
about a quarter of an inch from the cradle.
Table 1-2 on page
1-6.
Mounting Tab (2)
Mounting Screw (4)
Accessories2 - 11