8 - 12 MC70 Integrator Guide
Troubleshooting the Trigger Handle
Table 8-9
Problem
EDA battery does
not charge when
Trigger Handle is
placed in a cradle.
Cannot print to
printer.
EDA does not wake
from suspend mode
when trigger is
pressed.
Cause
Trigger Handle is not
Remove the Trigger Handle from the cradle and reinsert.
properly seated in the
cradle.
Power is not available
Ensure that power connections to the cradle are connected
to the cradle.
properly.
Printer cable not
Ensure cable is connected properly to the printer and
connected properly.
Trigger Handle.
The trigger only wakes
Press a key on the EDA to wake from the suspend mode.
the EDA from the
suspend mode if a
scanning application is
active.
Solution