Chapter 6 Mc7095 - Cdma Configuration; Introduction; Quick Startup Steps - Motorola MC70 Integration Manual

Chapter 6
Chapter 6

Chapter 6 MC7095 - CDMA Configuration

Introduction

This chapter explains how to activate an MC7095 EDA on a CDMA wireless network and establish settings.
CDMA is a form of wireless multiplexing in which data (e.g., Short Message Service) can be sent over multiple
frequencies simultaneously, optimizing the use of available bandwidth. In an CDMA system data is broken into
packets, each of which are given a unique identifier, so that they can be sent out over multiple frequencies and
then re-built in the correct order by the receiver.
When using the MC7095 EDA as a phone, services can include speed dialing, call tracking, voice mail, call
forwarding, conference calling and caller ID, depending on the type of service.
The integrated phone in the MC7095 can also be used as a modem to connect the MC7095 to an ISP or work
network. The MC7095 can connect to the Internet or work network using Cellular Line, or using the modem
specified by the mobile phone service provider.
NOTE Before the MC7095 can be used on a CDMA wireless network, a provider must be selected, a voice and
data-enabled service plan must be established and the MC7095 must be properly configured (where
applicable).
Refer to the MC70 User Guide for information on how to use the phone and services.

Quick Startup Steps

NOTE With active service from a provider, phone calls are established with or without a headset. A headset
MUST be connected for all voice call conversations.
To start using the MC7095 for phone and data connections:
Install the MC7095 main battery
1.
Charge the main battery and backup battery
2.
Start the MC7095 (see
3.
Activate the phone
4.
Configure settings
5.
Use the phone.
6.
(Installing and Removing the Main Battery on page
(Charging the Battery on page
Powering On the EDA on page
(MC7095 CDMA Phone Activation on page
(CDMA Settings on page 6-8).
MC7095 - CDMA Configuration
1-5).
1-7).
6-2).
1-3).