Overview; Precautions For Disassembling The Printer - Epson Stylus COLOR 800 Service Manual

3.1 Overview

This section describes procedures for disassembling main components of the EPSON Stylus
COLOR 800. Unless otherwise specified, you can assemble units or components by reversing
disassembly. Therefore, no assembly procedures are included. Precautions for disassembly or
assembly are described under the heading POINTS TO NOTE. Adjustments required after
assembling the unit are described under REQUIRED ADJUSTMENTS.

3.1.1 Precautions for Disassembling the Printer

See the precaution below when disassembling and assembling EPSON Stylus COLOR 800.
Disconnect the power cable before disassembling or assembling the printer.
Wear goggles to protect your eyes from ink. If ink gets in your eye, flush it with fresh
water and see a doctor immediately.
If ink comes in contact with your skin, wash it off with soap and water. If irritation occurs,
contact a physician.
A lithium battery is installed on the main board of this printer. Be sure to observe the
following instructions when servicing the battery:
ƒ Keep the battery away from any metal or other batteries so that electrodes of the
opposite polarity do not come in contact with each other.
ƒ Do not heat the battery or put it near fire.
ƒ Do not solder on any part of the battery. (Doing so may result in leakage of
electrolyte from the battery, burning, or explosion.)
ƒ Do not charge the battery. (An explosive may be generated inside the battery and
cause burning or explosion.)
ƒ Do not dismantle the battery. (The gas inside the battery may hurt your throat.
Leakage, burning, or explosion also may result.)
ƒ Do not install the battery in the wrong direction. (This may cause burning or
explosion.)
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according
to government laws and regulations.
Risque d'esplosion si la pile est remplacée incorrectment. Ne remplacer que par une pile
fu mêmetype ou d'un type équivalent recommandé par le fabricant. Eliminer les piles
déchargées selon lois et les règles de sécurité en vigueur.
Rev. A
WARNING
CAUTION
ATTENTION
Disassembly and Assembly
3-1