EPSON Stylus &2/25 800
Tubes linking the pump assembly are made of silicone, and a minor flaw can become a
crack. Therefore, use the exclusive tweezers designed for the tubes carefully when
positioning the tubes back onto the pins.
Handle the cap assembly carefully, and never touch the rubber portion and pad portion
of the caps.
Align the pin at the left edge with the hole in the right frame when positioning the cap
assembly, as show in Figure 3-40.
Make sure that the right edge of the cap assembly is located on the right of the left edge
of the top frame.
Tightening torque for the screws (CBS, 3x6, F/Zn) = 8 ~ 10 kg-cm.
3-32
Figure 3-40. Cap Assembly Removal
Rev. A
Need help?
Do you have a question about the Stylus COLOR 800 and is the answer not in the manual?