Download Print this page

Epson Stylus COLOR 800 Service Manual: Bk.-linear Adjustment

Hide thumbs

Advertisement

EPSON Stylus &RORU 800
4.2.6

BK.-Linear Adjustment

BK.-M Linear adjustment is required when replacing the printhead or disassembling and assembling the
CR unit, and is performed to adjust the vertical position of the color head by using the black head for the
basis. This adjustment, which depends on the physical operation, is accomplished by moving the head
vertical adjust lever assembled to the right side of the CR unit. By running this program, the head vertical
adjustment pattern is printed to identify the misalignment caused by the vertical gap between the Black
Head and Color Head. According to the printed pattern, adjust the gap by moving the head vertical
adjustment lever. Therefore this adjustment has no value to be written into the EEPROM on the C202
MAIN board. The adjustment procedure is as follows;
1.
Set this program to FFD on your PC and turn the PC on.
2.
The program automatically sets up and the following menu appears on the screen.
3.
Enter "1" for "Select menu : ?" to select "Input of Customer data" in the menu.
4.
Press "ENTER" key, and the menu below appears.
5.
Enter the 4-column code which corresponds to the destination for "Memory-SW data (4 col data)"
and press "ENTER" key. (See the code list in Page 4-6.)
6.
Enter "2" for "Select menu : ?" to select "Adjustment/Print inspection" in the menu.
4-16
Figure 4-20. Main Menu
Figure 4-21. Input of Customer Data
Rev. A

Advertisement

Table Of Contents

Troubleshooting

   Also See for Epson Stylus COLOR 800

   Related Manuals for Epson Stylus COLOR 800

   Related Content for Epson Stylus COLOR 800

Comments to this Manuals

Symbols: 0
Latest comments: