Tools - Epson Stylus Color C70 Service Manual

EPSON Stylus COLOR C70/C80
Never remove the ink cartridge from the carriage unless this
manual specifies to do so.
When transporting the printer after installing the ink cartridge,
be sure to pack the printer for transportation without removing
the ink cartridge.
Use only recommended tools for disassembling, assembling or
adjusting the printer.
Observe the specified torque when tightening screws.
Apply lubricants and adhesives as specified. (See Chapter 6 for
details.)
Make the specified adjustments when you disassemble the
printer.
(See Chapter 5 for details.)
When assembling, if an ink cartridge is removed and needs to be
installed again, be sure to install a new ink cartridge because of
the following reasons;
1. Once the ink cartridge mounted on the printer is removed, air
comes in and creates bubbles in the cartridge. These bubbles clog
ink path and cause printing malfunction.
2. If an ink cartridge in use is removed and is reinstalled, ink
quantity will not be detected correctly since the counter to check
ink consumption is cleared.
Because of the reasons above, make sure to return the printer to
the user with a new ink cartridge installed.
Make sure the tip of the waste ink tube is located at correct
position when reassembling the waste ink tube. Otherwise it will
cause ink leakage.
Disassembly and Assembly

4.1.2 Tools

Use only specified tools to avoid damaging the printer.
Table 4-1. Special Tool List
Name
Phillips Screw Driver (No.1)
Phillips Screw Driver (No.2)
Tweezers
Overview
Revision A
Supplier Parts No.
EPSON B743800100
EPSON B743800200
EPSON B741000100
98