Epson Stylus Color C70 Service Manual page 118

EPSON Stylus COLOR C70/C80
8. Remove the Timing Belt from the Pinion Gear on the CR Motor.
CR Printer Gear
Figure 4-43. Timing Belt Removal
9. Use tweezers or similar to lift up and remove the compressed spring inside the
Pulley Driven Holder.
Figure 4-44. Spring Removal
Disassembly and Assembly
Timing Belt
[Front-Left side]
Spring
Pulley Driven Holder
10. Remove the screw (2) (CBS 3x6 {8±1 kgf.cm}), and then remove the Holder
Stopper.
When re-installing the Holder Stopper, secure it so that there is a
clearance of 2–5 mm between it and the Pulley driven holder.
11. The Pulley Driven Holder should be moved approximately 10 mm to the left.
Remove the Pulley Driven Holder Unit so that the entire Pulley Driven Holder
Unit can be removed from the frame.
Pulley Driven Holder
Approx. 10mm
Figure 4-45. Pulley Driven Holder Removal
Disassembly
C.B.S 3x6
Holder Stopper
2mm~5mm Gap
Pulley Driven Unit
Timing Belt
Revision A
118