Pe Actuator Removal; Encoder Unit Board Removal - Epson Stylus Color C70 Service Manual

EPSON Stylus COLOR C70/C80

4.2.10 PE Actuator Removal

1. Remove the ASF Unit. (Refer to Sections 4.2.2)
2. Remove the screw (2) (CBS 3x6 {8±1 kgf.cm}) that is securing the PE Actuator.
3. Remove the PE Actuator.
C.B.S 3x6
Figure 4-59. PE Actuator Removal
When the PE Actuator is removed together with the base, the
Torsion Spring will be easier to remove, so the setting should be
made as shown in the diagram below.
Disassembly and Assembly
PE Actuator
PE Lever Base

4.2.10.1 Encoder Unit Board Removal

1. Remove the Printer Mechanism. (Refer to Sections 4.2.1.6)
2. Disconnect the connector (white 4-pin) from the Encoder Unit Board Assembly.
3. Remove the screw (11)(CBP 2.5x5 {3.5±0.5 kgf.cm}) that is securing the Encoder
Unit Board Assembly.
4. Remove the Rotary Encoder so that the Encoder Unit Board can be turned to the
left.
Disassembly
Torsion Spring
PE Actuator
Figure 4-60. PE Actuator
Revision A
125