Front Paper Guide Removal - Epson Stylus Color C70 Service Manual

EPSON Stylus COLOR C70/C80
Carry out all of the adjustments in Table 5-1 in the order given
when removing or replacing the CR guide shaft.
Both of the Carriage Unit Bushings are different from the bushes
used in previous models because the Oil Pads and fixing brackets
which are attached to the bushings (one each per bushing) have
different ASP designations from the Carriage Unit because of the
manufacturing process and parts delivery method used.
Accordingly, the availability of the bushings as a set should be
checked beforehand when quoting for ASP work on the Carriage
Unit.
Securing Spring
Figure 4-51. Oil Pads and fixing brackets
Disassembly and Assembly

4.2.7 Front Paper Guide Removal

1.
2.
3.
Sub Oil Pad
Disassembly
Remove the Paper Eject Frame Unit. (Refer to Steps 1 to 10 in Section 4.2.5.)
Remove the two EJ Roller Holders Assembly. (Refer to Figure4-52)
Remove the two screws (2) (CBS 3x6 {8±1 kgf.cm}) that are securing the Front
Paper Guide.
To remove the EJ Roller Holder, use a flat-tipped screwdriver to
lift the EJ Roller Holder upward.
The procedure below describes the method of removing the Front
Paper Guide. If the procedure is not carefully followed, the power
coating on the surface of the PF Roller may come off, and this
could have an adverse effect on the paper feed pitch to an extent
that could be noticeable to the user. Accordingly, when removing
the Front Paper Guide, take particular care not to touch the
surface of the PF Roller. Furthermore, this should also be
observed when installing the PF Roller. Specifically, contact with
the surface of the PF Roller can be avoided by rotating it to the
front while removing it.
Revision A
121