Printer Mechanism Unit Removal - Epson Stylus Color C70 Service Manual

Hide thumbs Also See for Stylus Color C70:
Table of Contents

Advertisement

EPSON Stylus COLOR C70/C80
Use a flat-tipped screwdriver or your finger to disengage the Hook
from the notch at the bottom of the Lower Case.
When removing the Middle Housing, be careful no to let the
screw fixing lip at the left of the printer come into contact with
the PG Lever Tension Spring and cause it to fly off.
Be careful not to break the Middle Housing Hook Holes.
Disassembly and Assembly

4.2.1.6 Printer Mechanism Unit Removal

1.
Remove the Middle Housing. (Refer to Section 4.2.1.5.)
2.
Remove the screw (2) (CBS 3x6 {6±1 kgf.cm}) and the two screws (3) (CBS 4x12
{6±1 kgf.cm}) that are securing the Lower Case.
C.B.P 4x12
[Left-Front side]
Figure 4-10. Screws Securing the Lower Case
Disassembly
C.B.S 3x6
[Right-Front side]
Lower Case
CR Unit
C.B.P 4x12
[Right-Front side]
Revision A
105

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stylus color c80

Table of Contents